Do Screens Reduce Airflow? How Much, by Mesh Type
Yes, and by a lot more than "slightly". In measured greenhouse vents, insect screens that were 25% to 53% open cut the ventilation rate by 16% to 77% compared with no screen. Even screens 50% and 60% open, close to ordinary window mesh, cost about a third to over half of the airflow in the studies cited. Standard 18x16 fiberglass is about 63% open, so it sits at the gentle end of that range. A 20x20 no-see-um mesh or a SunTex 80 solar fabric sits well inside it, and SunTex 90 is more closed than any screen in these tests.
Key takeaways
- Open area (porosity, or openness factor) is the share of the screen that is holes. Less open area means less air through.
- A 2016 study collected earlier results: screens 25% to 53% open cut greenhouse ventilation by 16% to 77% against no screen.
- In the same study, swapping a 35% screen for a 26.3% screen made the air inside 40.7% slower (0.27 to 0.16 m/s).
- Screens 50% and 60% open, the closest tested to window mesh, still cost about 33% and 54-56% of the ventilation.
- Same thread count does not mean same airflow. Two screens of one count and almost the same open area differed by a third.
What "open area" means and why it sets the breeze
A screen is a woven grid. The open area is the share of its face that is holes, not yarn. Greenhouse researchers call it porosity. Solar fabric makers call it openness factor. All three mean the same thing: a screen that is 60% open is 40% yarn.
The breeze you feel depends on the ventilation rate. That is the volume of outside air that passes through the opening in a given time. A screen lowers it in two ways. The yarn covers part of the opening. And the air has to squeeze through small holes, which costs it pressure, so less of the wind's push turns into flow.
The 2006 paper by Valera, Álvarez and Molina in the Spanish Journal of Agricultural Research puts the rule plainly. Screens "reduce the surface area of the greenhouse devoted to ventilation," and that reduction "is inversely related to the porosity of the mesh." Lower porosity, less air.
Thread count is not open area. The open area depends on the count and on how thick each strand is. A thick coated yarn at 20 per inch leaves smaller holes than a thin wire at 20 per inch. How the site's mesh figures were worked out is on our screen mesh openness factor page.
What the wind-tunnel and greenhouse studies measured
Two open-access papers from the University of Almería, in Spain, measure this directly. Both test the insect screens growers fit over greenhouse vents.
The wind tunnel (2006). Valera and colleagues pushed air through 11 commercial screens and measured the pressure drop. That is the pressure the air loses getting through. The screens ran from 28.8% to 48.3% open. Their fitted curves show how fast resistance climbs as open area falls. By our calculation from their Table 2, at a 1 m/s airflow (about 2 mph) the 28.8% screen needs about 14.5 Pa to push air through. The 48.3% screen needs about 3.0 Pa. So the more closed screen takes about five times the pressure for the same flow. At 2 m/s the gap is about 4.4 times.
The greenhouse (2016). López, Molina-Aiz, Valera and Peña, writing in Sensors, fitted three screens to the roof vents of one greenhouse split into two halves. Screen 1 was 35.0% open, screen 2 was 26.3% and screen 3 was 36.0%. With screen 2 on one half and screen 1 on the other, mean air speed at midday was 0.16 m/s against 0.27 m/s. That is "a 40.7% reduction in inside air velocity." The paper is careful about this number. With the same screen on both halves, the two sides still differed by 17.6%, which it puts down to vent area or sensor position.
The same paper sums up the earlier work: "Insect-proof screens with porosities from 25% to 53% were found to reduce the ventilation rate in comparison to a greenhouse without such screens between 77% and 16%." It also cites two results for more open screens. Katsoulas, Kittas and colleagues found that a 50% screen left the vent passing 0.67 of its unscreened air, about a third less. They also found the air inside a tunnel greenhouse was 58% slower with 50% screens than with none. A 60% screen, in another study, left 0.44 to 0.46, a loss of about 55%.
Those two figures do not line up neatly. A 60% screen cost more than a 50% one. They come from different greenhouses with different vents, and that is a lesson in itself: the opening matters too, not just the mesh.
Worked example: reading one screen's numbers
How much airflow each screen mesh costs
The table puts each mesh beside the nearest screens measured. Open area is from the makers' sheets on our mesh pages; airflow is what the studies found, or what we calculated from their tables.
| Mesh | Open area | Nearest screens measured | Airflow lost against no screen |
|---|---|---|---|
| 18x16 or 18x14 standard fiberglass | About 58-63% | 50% and 60% open greenhouse screens | About 33% (50% open) and 54-56% (60% open) |
| 20x20 no-see-um fiberglass | 42% listed, about 52% from its hole size | 35-36% and 50% open screens | About 33% at 50% open, 58-72% at 35-36% open (our calculation, light wind) |
| SunTex 80, Textilene 80 | About 25%, 23% | 26.3% open screen | About 79% in light wind, 67% at 1 m/s (our calculation); 77% is the top of the published range |
| SunTex 90, Textilene 90 | About 10%, 13% | None; no study read tested a screen this closed | No measured figure. More than the 80 row, since it is less open |
Standard insect mesh. Streme lists its 18x16 fiberglass at 63% open (see no-see-um mesh size), and Phantom Screens NZ about 58% for its insect mesh (see pet mesh for retractable screen doors). With 14 strands one way instead of 16, 18x14 is a little more open. No study we read tested a 63% screen, so the 50% and 60% screens are the nearest evidence, not an exact match.
No-see-um mesh. Streme lists its 20x20 fiberglass at 42% open, though its stated hole size works out to about 52%. Either way it sits inside the 25-53% band where losses of 16% to 77% were measured.
Solar fabric, 80 grade. Phifer's card puts SunTex 80 at approximately 25% open, and Twitchell lists Textilene 80 at 23% (compared in SunTex 80 vs 90 vs 95 and Textilene vs SunTex). That is the bottom edge of what was tested, and the 26.3% screen in the worked example is the match.
Solar fabric, 90 grade. SunTex 90 is approximately 10% open and Textilene 90 is 13%. Neither paper tested anything that closed, so we give no number. The direction is not in doubt: less open area means more resistance, and these fabrics have roughly half the open area of the 80 grade.
Do screens reduce airflow "only slightly"?
No. RiteScreen's April 2026 post, Do Window Screens Block Breezes?, says screens "can reduce airflow slightly depending on the mesh, screen condition, and fit." It also says that standard sizes "like 18×16 or 20×20 strands per inch, allow plenty of air movement." It gives no measurement for either claim.
The measured figures say otherwise. The most open screens tested, 50% and 60%, cost a third to over half of the airflow, and a 20x20 fiberglass mesh sits inside the 25-53% band that cost 16% to 77%. None of that is slight.
Why does "slightly" persist? A standard screen looks like it is mostly holes, so it reads as no obstacle. RiteScreen is right that a clean mesh and a screen that sits flat both matter. It is wrong about the size of the effect.
A stronger breeze loses a smaller share
The 2016 paper shows that a screen's discharge coefficient rises with air speed. Screen 1's own coefficient goes from 0.207 at 0.25 m/s to 0.331 at 1.0 m/s. Run the same division as the worked example at 1.0 m/s and the losses shrink. Screen 2 drops from about 79% to 67%, screen 1 from 72% to 58%, and screen 3 from 58% to 47% (our calculation from the paper's Table 4).
So a screen costs you most on the light, still evenings when you want every bit of breeze. In a stiff wind it takes a smaller share, though still a large one.
What to do with this on a porch or window
- Put the most open mesh on the breeze side. Use standard 18x14 or 18x16 on the side that faces the evening wind. It is the most open of the meshes here, and screens nearly that open still cost a third to over half in the studies.
- Use 20x20 only where midges are the problem. Going from 63% to 42% listed open area is a third less open face. That is a bigger step than the two the 2016 paper reports: 39.0% to 33.5% cost 16% of the ventilation (measured in the team's earlier study), and 35.0% to 26.3% cost a predicted 26%. Fit it on the openings that face the marsh, as our porch and lanai screen enclosures guide sets out.
- Keep solar fabric where the sun is. An 80 or 90 grade screen on the west side does its job in the afternoon. On a retractable screen, roll it up when the sun goes down and the breeze comes back. The trade-off, including heads that carry both an insect and a solar screen, is in solar screens vs insect screens.
What these numbers do not cover
A greenhouse vent is not a porch. The 2016 study measured roof vents opened to 14°, with 0.25 m/s as its reference speed through the screen. A porch is open on several sides, and wind can come at it from any angle. The percentages here tell you the size of the effect, not the exact breeze you will feel on your own porch. Dirt lowers open area, and the 2006 paper cites a 2002 study, by Linker and colleagues, on the "increased resistance to flow" from dust on insect screens. Our guide to cleaning retractable and solar screens covers keeping mesh clear. Solar fabrics are also thicker: SunTex 80 is 0.040 in (about 1 mm), against 0.28-0.46 mm for the 2006 screens, and the 2016 paper found thickness changes airflow at the same open area. That is one more reason the 90-grade row has no number. These studies did not measure comfort, cooling or the effect of a ceiling fan.
Bottom line
Screens do not cut the breeze slightly. Screens 25% to 53% open cost 16% to 77% of greenhouse ventilation, and the 50% and 60% screens tested still cost a third to over half. Standard 18x16 mesh, at about 63% open, is the gentlest choice. 20x20 no-see-um mesh sits inside the measured range, SunTex 80 near its harsh end, and SunTex 90 beyond it. Put the most open mesh on the breeze side and roll solar fabric up when the sun goes.
Sources
- Valera, D. L., Álvarez, A. J. and Molina, F. D., Aerodynamic analysis of several insect-proof screens used in greenhouses, Spanish Journal of Agricultural Research 4(4), 273-279, 2006.
- López, A., Molina-Aiz, F. D., Valera, D. L. and Peña, A., Wind Tunnel Analysis of the Airflow through Insect-Proof Screens and Comparison of Their Effect When Installed in a Mediterranean Greenhouse, Sensors 16(5), 690, 2016. The Kittas and Katsoulas results are as cited in this paper.
- RiteScreen, Do Window Screens Block Breezes? What Affects Airflow Most, April 3, 2026.
- Open-area figures: Streme, Phantom Screens NZ, Phifer and Twitchell sheets, as cited on the linked Retract Wise pages.
Frequently asked questions
Does a window screen block a breeze?
It does not stop it, but it cuts it a lot. In measured greenhouse vents, screens 50% and 60% open cost about a third to over half of the airflow. Standard window mesh is about 58-63% open, so expect a loss on that order, not a few percent.
Is 18x14 better for airflow than 18x16?
A little. With the same strand, fewer strands one way means a bit more open area. The gap is small next to the step down to 20x20 or to solar fabric.
Does no-see-um mesh reduce airflow?
Yes. Streme lists 42% open for its 20x20 fiberglass against 63% for standard 18x16. Screens in that range cost 16% to 77% of greenhouse ventilation. Use it only on the sides where midges come in.
How much breeze does a solar screen let through?
No study we read tested a solar fabric. SunTex 80, at about 25% open, matches a 26.3% greenhouse screen that cut vent airflow by about 79% in light wind. SunTex 90, at about 10% open, will pass less than that.
Sources and standards consulted
- EN 13561:2015, External blinds and awnings (covers vertical external screens and wind classes) (CEN)
- Screen mesh specification sheets (fiberglass, polyester and PVC-coated meshes) (manufacturer documentation)
- Energy Efficient Window Attachments (U.S. Department of Energy, Energy Saver)
- Attachments Energy Rating Council (AERC) rating program (AERC)
See how we research for our sourcing and verification process.